Using the Radio test (short-range) sample

The Radio test sample is used to control the short-range device. The Radio test firmware supports configuration of the short-range radio in specific modes and with various TX and RX parameters to test its performance.

For more information on the samples in nRF Connect SDK, see the following:

• Overall description: Radio test (short-range) sample.

• Description of using PuTTY as the terminal application for controlling the Device Under Test (DUT): Testing and debugging an application.

• Description of sub-commands for configuring the radio: User interface for short-range Radio test.

Note

The Radio test (short-range) runs on a different UART that is connected to the nRF5340 network core (VCOM0). For more information, see VCOM settings.

Subpages:

• Using the Bluetooth Low Energy Radio test firmware
• Using the Bluetooth Low Energy Radio test for PER measurements
• Using the Thread Radio testing
• Using Thread Radio test for PER measurements