Setting regulatory domain

In the Wi-Fi® Radio test sample, world regulatory domain regulations apply by default. To change the regulatory domain to a specific country, use the reg_domain subcommand.

Note

Set the reg_domain subcommand for each session and on reboot of the development board, not with every command set described in this section.

For more information, see nRF70 Series operating with regulatory support.

To change the domain, use the following command:

uart:~$ wifi_radio_test reg_domain <country code>

To remove regulatory domain restrictions, use the following command:

uart:~$ wifi_radio_test bypass_reg_domain 1

To re-enable regulatory domain restrictions, use the following command:

uart:~$ wifi_radio_test bypass_reg_domain 0

For more information, see Using the Wi-Fi Radio test sample and Using the Radio test (short-range) sample.