TEMP blocking

TEMP blocking

The sample demonstrates a functionality of the nrfx_temp driver operating in the blocking mode.

Requirements

The sample supports the following development kits:

Board	Support
nrf52dk_nrf52832	Yes
nrf52833dk_nrf52833	Yes
nrf52840dk_nrf52840	Yes
nrf5340dk_nrf5340	Yes
nrf54l15dk_nrf54l15	Yes
nrf9160dk_nrf9160	No

Overview

Application initializes the nrfx_temp driver and starts operating in the blocking mode. Temperature is measured with relevant messages logged until a number of measurements performed is equal to the value specified by the user.

‍For more information, see TEMP driver - nrfx documentation.

Wiring

To run this sample, no special configuration is needed. You should monitor the output from the board to check if it is as expected.

Building and running

To run this sample, build it for the appropriate board and then flash it as per instructions in Building and running section.

Sample output

You should see the following output:

- "Starting nrfx_temp blocking example."
- "Measured temperature: <temp_value> [C]"
- "Measured temperature: <temp_value> [C]"
- "Measured temperature: <temp_value> [C]"
- "Measured temperature: <temp_value> [C]"
- "Measured temperature: <temp_value> [C]"

‍In the output, temp_value should be displayed as a temperature value in Celsius rounded to two decimal places.