◆ sdc_hci_cmd_le_remove_device_from_resolving_list()

uint8_t sdc_hci_cmd_le_remove_device_from_resolving_list ( const sdc_hci_cmd_le_remove_device_from_resolving_list_t * p_params )

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Remove Device From Resolving List.

The description below is extracted from Core_v6.3, Vol 4, Part E, Section 7.8.39

This command is used to remove one device from the resolving list used to resolve Resolvable Private Addresses in the Controller.

This command shall not be used when address resolution is enabled in the Controller and:

• Advertising (other than periodic advertising) is enabled, • Scanning is enabled, or • an HCI_LE_Create_Connection, HCI_LE_Extended_Create_Connection, or HCI_LE_Periodic_Advertising_Create_Sync command is pending.

This command may be used at any time when address resolution is disabled in the Controller.

Errors:

See Section 4.5.2 for a list of error types and descriptions.

Type   Condition                                  Error code
MC     The device is not in the resolving list.   Unknown Connection Identifier (0x02)

Event(s) generated (unless masked away):

When the HCI_LE_Remove_Device_From_Resolving_List command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in] p_params Input parameters.

Return values

0	if success.

Returns: Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.