sdc_hci_cmd_le_transmitter_test_v2()

uint8_t sdc_hci_cmd_le_transmitter_test_v2

(

const sdc_hci_cmd_le_transmitter_test_v2_t *

p_params

)

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Transmitter Test [v2].

The description below is extracted from Core_v6.3, Vol 4, Part E, Section 7.8.29

This command is used to start a test where the IUT generates test reference packets at a fixed interval. The Controller shall transmit at the power level indicated by the TX_Power_Level parameter.

The TX_Channel and PHY parameters specify the RF channel and PHY to be used by the transmitter. If the Host sets the PHY parameter to a PHY that the Controller does not support, including a value that is reserved for future use, the Controller shall return the error code Unsupported Feature or Parameter Value (0x11).

The Test_Data_Length and Packet_Payload parameters specify the length and contents of the Payload of the test reference packets. An LE Controller supporting the HCI_LE_Transmitter_Test command shall support Packet_Payload values 0x00, 0x01 and 0x02. An LE Controller supporting the LE Coded PHY shall also support Packet_Payload value 0x04. An LE Controller may support other values of Packet_Payload.

Event(s) generated (unless masked away): When the HCI_LE_Transmitter_Test command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]

p_params

Input parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.