 |
nrfxlib API 3.3.99
|
|
nrfxlib API 3.3.99
|
| uint8_t sdc_hci_cmd_le_transmitter_test_v3 | ( | const sdc_hci_cmd_le_transmitter_test_v3_t * | p_params | ) |
#include <softdevice_controller/include/sdc_hci_cmd_le.h>
LE Transmitter Test [v3].
The description below is extracted from Core_v6.3, Vol 4, Part E, Section 7.8.29
This command is used to start a test where the IUT generates test reference packets at a fixed interval. The Controller shall transmit at the power level indicated by the TX_Power_Level parameter.
The TX_Channel and PHY parameters specify the RF channel and PHY to be used by the transmitter. If the Host sets the PHY parameter to a PHY that the Controller does not support, including a value that is reserved for future use, the Controller shall return the error code Unsupported Feature or Parameter Value (0x11).
The Test_Data_Length and Packet_Payload parameters specify the length and contents of the Payload of the test reference packets. An LE Controller supporting the HCI_LE_Transmitter_Test command shall support Packet_Payload values 0x00, 0x01 and 0x02. An LE Controller supporting the LE Coded PHY shall also support Packet_Payload value 0x04. An LE Controller may support other values of Packet_Payload.
The CTE_Length and CTE_Type parameters specify the length and type of the Constant Tone Extension in the test reference packets. If the CTE_Type parameter is set to 0x01 and the Controller does not support 1 µs switching, the Controller shall return the error code Unsupported Feature or Parameter Value (0x11). If CTE_Length is not zero and PHY specifies a PHY that does not allow Constant Tone Extensions, the Controller shall return the error code Command Disallowed (0x0C).
The Switching_Pattern_Length and Antenna_IDs[i] parameters specify the antenna switching pattern. They are only used when transmitting an AoD Constant Tone Extension and shall be ignored when transmitting an AoA Constant Tone Extension.
If the Controller determines that any of the Antenna_IDs[i] values do not identify an antenna in the device's antenna array, it shall return the error code Unsupported Feature or Parameter Value (0x11).
Note: Some Controllers may be unable to determine which values do or do not identify an antenna.
Event(s) generated (unless masked away): When the HCI_LE_Transmitter_Test command has completed, an HCI_Command_Complete event shall be generated.
| [in] | p_params | Input parameters. |
| 0 | if success. |
1.12.0