◆ nrf_wifi_sys_commands

System commands.

Enumerator
NRF_WIFI_CMD_INIT	Command to initialize RPU and RPU responds with NRF_WIFI_EVENT_INIT_DONE
NRF_WIFI_CMD_TX	command to send a Tx packet in radiotest mode
NRF_WIFI_CMD_IF_TYPE	Unused
NRF_WIFI_CMD_MODE	command to specify mode of operation
NRF_WIFI_CMD_GET_STATS	command to get statistics
NRF_WIFI_CMD_CLEAR_STATS	command to clear statistics
NRF_WIFI_CMD_RX	command to ENABLE/DISABLE receiving packets in radiotest mode
NRF_WIFI_CMD_PWR	Command to measure battery voltage and RPU responds with NRF_WIFI_EVENT_PWR_DATA
NRF_WIFI_CMD_DEINIT	RPU De-initialization
NRF_WIFI_CMD_SRCOEX	Command for WIFI & SR coexistence
NRF_WIFI_CMD_RF_TEST	Command to start RF test
NRF_WIFI_CMD_HE_GI_LTF_CONFIG	Configure HE_GI & HE_LTF
NRF_WIFI_CMD_UMAC_INT_STATS	Command for getting UMAC memory statistics
NRF_WIFI_CMD_RADIO_TEST_INIT	Command for Setting the channel & Rf params in radiotest mode
NRF_WIFI_CMD_RT_REQ_SET_REG	Command for setting country in radiotest mode
NRF_WIFI_CMD_TX_FIX_DATA_RATE	Command to enable/disable fixed data rate in regular mode
NRF_WIFI_CMD_CHANNEL	Command to set channel in promiscuous, monitor & packet injector mode
NRF_WIFI_CMD_RAW_CONFIG_MODE	Command to configure promiscuous mode, Monitor mode & packet injector mode
NRF_WIFI_CMD_RAW_CONFIG_FILTER	Command to configure promiscuous mode, Monitor mode filter
NRF_WIFI_CMD_RAW_TX_PKT	Command to configure packet injector mode or Raw Tx mode
NRF_WIFI_CMD_RESET_STATISTICS	Command to reset interface statistics
NRF_WIFI_CMD_OFFLOAD_RAW_TX_PARAMS	Command to configure raw tx offloading parameters
NRF_WIFI_CMD_OFFLOAD_RAW_TX_CTRL	Command to enable/disable raw tx offloading