Using the Wi-Fi Radio test sample

The Wi-Fi® Radio test sample is used to directly configure and control the Wi-Fi radio on an nRF70 Series device. The Wi-Fi Radio test firmware supports the configuration of the Wi-Fi radio in specific modes and with various TX and RX parameters to test its performance.

For more information on the samples in nRF Connect SDK, see the following:

• Overall description: See either the Wi-Fi: Radio test (Multi domain) sample or the Wi-Fi: Bluetooth LE Wi-Fi Radio test (Single domain) sample.

• Description of the sub-commands for configuring the radio: Wi-Fi Radio test subcommands.

Subpages:

• Build instructions
  • Stand-alone Wi-Fi Radio test
  • Combined build for Radio test and Wi-Fi Radio test
• Setting regulatory domain
• Using the Wi-Fi Radio sample for transmit tests
  • Order of commands
  • Adjusting TX power
  • TX inter-packet gap
• Using the Wi-Fi Radio test for PER measurements
  • PER measurements in 802.11b mode
  • PER measurements in 802.11g mode
  • PER measurements in 802.11a mode
  • PER measurements in 802.11n mode
  • PER measurements in 802.11ac mode
  • PER measurements in 802.11ax mode