EFR32BG27 2.4 GHz 4 dBm DCDC Buck CSP (BG27-RB4110B)

Overview

The EFR32BG27 +4 dBm Radio Board (BG27-RB4110B) in CSP package is a plug-in board for the Wireless Starter Kit Mainboard (BRD4001A) and the Wireless Pro Kit Mainboard (BRD4002A). It is a complete reference design for the EFR32BG27 Wireless SoC, with matching network and a PCB antenna for 4 dBm output power in the 2.4 GHz band.

See Radio Boards for more information about the Wireless Mainboard platform.

Hardware

  • EFR32BG27C320F768GJ39 SoC

  • CPU core: ARM Cortex®-M33 with FPU, DSP and TrustZone

  • Memory: 768 kB Flash, 64 kB RAM

  • Transmit power: up to +4 dBm

  • Operation frequency: 2.4 GHz

  • Crystals for LFXO (32.768 kHz) and HFXO (38.4 MHz)

  • 8 Mbit SPI NOR Flash

For more information about the EFR32BG27 SoC and BRD4110B board, refer to these documents:

Supported Features

The bg27_rb4110b board supports the hardware features listed below.

on-chip / on-board
Feature integrated in the SoC / present on the board.
2 / 2
Number of instances that are enabled / disabled.
Click on the label to see the first instance of this feature in the board/SoC DTS files.
vnd,foo
Compatible string for the Devicetree binding matching the feature.
Click on the link to view the binding documentation.

System Clock

The EFR32BG27 SoC is configured to use the HFRCODPLL oscillator at 76.8 MHz as the system clock, locked to the 38.4 MHz external crystal oscillator on the board.

Serial Port

The EFR32BG27 SoC has two USARTs and one EUSART. USART1 is connected to the board controller and is used for the console.

Buttons and LEDs

This board has two buttons and two LEDs that share GPIO pins. If an application wants to use both a button and a LED with the same number (e.g. button 0 and LED 0), it needs to time multiplex the two functions.

Programming and Debugging

The bg27_rb4110b board supports the runners and associated west commands listed below.

flash debug

Connect the BRD4002A mainboard with a mounted BRD4110B radio board to your host computer using the USB port.

Here is an example for the Hello World application.

# From the root of the zephyr repository
west build -b bg27_rb4110b samples/hello_world
west flash

Open a serial terminal (minicom, putty, etc.) with the following settings:

  • Speed: 115200

  • Data: 8 bits

  • Parity: None

  • Stop bits: 1

Reset the board and you should see the following message in the terminal:

Hello World! bg27_rb4110b

Bluetooth

To use Bluetooth functionality, run the command below to retrieve necessary binary blobs from the Silicon Labs HAL repository.

west blobs fetch hal_silabs

Then build the Zephyr kernel and a Bluetooth sample with the following command. The Observer sample application is used in this example.

# From the root of the zephyr repository
west build -b bg27_rb4110b samples/bluetooth/observer